Installation Steps

• 1. Mix 5 pumps of dish soap in a spray bottle of water.

• 2. Clean the places where your stripes are going well with alcohol and a clean rag.

• 3. Do NOT install in direct sunlight, because it can cause bubbles under the vinyl. Install in a garage if you can or in good shady area.

• 4. Wet the the place down where the first stripe in going, then remove the backing paper away from that stripe.

• 5. Wet the back of the vinyl itself, use plenty of water, it helps the more you wet it. Make sure the backing paper gets 100% removed before you wet the vinyl down. The backing paper that says 3M on it can not get wet at all.

• 6. Once paper is removed, lay the vinyl piece on the vehicle. You should be able to move the stripe around easily. If it's sticking to the paint before you've squeegeed out the water, you need more soap in your water bottle. It should move around easily on the vehicle.

• 7. Once lined up on the vehicle squeegee out all the soapy water, using a plastic squeegee. Do the same thing to the other stripes.

• 8. Let dry 45 minutes before you remove the top layer of tape. You shouldn't have any bubbles if done properly. If you do have a few small bubbles you can take a pin and pop them